Slip-on flange

ASME B16.5 slip-on flange on a pipe stub: short tapered hub, bore B a little over the pipe OD, drilled bolt holes, RF / FF / RTJ facing. The pipe end is set back from the face by the inside fillet weld leg (the smaller of the wall and 6 mm) and an outside fillet weld closes the hub end, as ASME B31.3 Fig. 328.5.2B shows. Hub length Y comes from the B16.5 slip-on table for each class. Where B16.5 has no slip-on flange (Class 1500 above NPS 2-1/2, Class 2500), the next lower class that has one is used.

Installation

Copies piping/slip-on-flange.tsx and the shared lib/ into src/components/deck-twin/. Needs three, @react-three/fiber and @react-three/drei. See installation for the manual route.

Usage

import { Canvas } from '@react-three/fiber'
import { OrbitControls } from '@react-three/drei'
import { Stage } from './components/deck-twin/lib/stage'
import { SlipOnFlange } from './components/deck-twin/piping/slip-on-flange'

export default function Scene() {
  return (
    <Canvas shadows camera={{ position: [8, 5, 9], fov: 35 }}>
      <Stage>
        <SlipOnFlange />
      </Stage>
      <OrbitControls makeDefault />
    </Canvas>
  )
}

Props

P&ID

In section: a flange with a short hub slid over the pipe, the pipe end set back from the face, with fillet welds inside the bore and at the hub. On P&IDs a short bar across the line.

tag SOASME B16.5 flange types drawn in half-section (GA / isometric detail convention); on P&IDs every flange is a short bar

Pipe passing into the flange bore with two fillet welds = slip-on. Weld-neck has a long tapered hub and one butt weld.

Piping class / flange bill of materials (ASME B16.5) fields and the props they set

Nominal sizenps

Pressure classrating

Facingfacing

Pipe scheduleschedule

Tag numbertag

Typical suppliers

All Metals & Forge Group. The geometry is generic and sized from public standards. It is not vendor CAD.

For agents

Machine-readable entry with props, ranges, defaults and ports:

Or fetch /r/slip-on-flange.json, or copy a ready-made instruction:

Add the Deck Twin "Slip-on flange" component to this project. Run `npx -y https://decktwin.com/cli/deck-twin-0.2.2.tgz add slip-on-flange` (it copies the file and the shared lib into src/components/deck-twin/), then `npx -y https://decktwin.com/cli/deck-twin-0.2.2.tgz info slip-on-flange` for its props, ranges and ports. Render <SlipOnFlange /> inside a React Three Fiber <Canvas shadows>, wrapped in <Stage> from src/components/deck-twin/lib/stage. Set props from my data (metres, NPS in inches, ASME class) and leave the rest at defaults. Install three, @react-three/fiber, @react-three/drei and @types/three if they're missing. Full guide: https://decktwin.com/skill/SKILL.md